4. There is a dielectric-filled parallel-planar metallic waveguide oriented in the way that guided waves propagate along z direction, and the separation d of two parallel is along y axis. Ignoring the fringing effect, the following field component of fundamental mode supported by the waveguide is non-zero:
(A) E_z
(B) E_x
(C) H_y
(D) H_x

1. Which of the following statements is true? (A) Dynamic electromagnetic forces satisfy Newton's third law (B) Static electromagnetic forces satisfy momentum conservation (C) Given the electric field E =  and charge q, the physical meaning of qA is energy. (D) All of the above are true

2. Which of the following cannot support TEM modes (ignoring the fringing effect): (A) Two-wire line (B) Rectangular waveguide (C) Coaxial cable/line (D) Microstrip line

3. Which of the following statements about the vector potential A is always true? (A) ∇ × A = B (B) ∇ · A = 0 (C) ∇²A = -μ₀J (D) None of the above

5. In the complex notation (also called the phasor notation), we can express a monochromatic plane wave as E = E₀ei(k·r-ωt). How do we calculate the time-averaged Poynting vector in this notation? (A) E × H (B) Re[E × H] (C) Re[E × H*] (D) None of the above

6. Consider a plane wave traveling in a lossy material. The electric field is given by E = E₀ei(kz-ωt), where k equals 1 + 0.1i (μm⁻¹). The intensity of the plane wave can be expressed as I = I₀e-αz, where α is the absorption coefficient. Please calculate α. (A) 2 (μm⁻¹) (B) 0.2 (μm⁻¹) (C) 0.1 (μm⁻¹) (D) None of the above

7. If A = r cosφ r̂ + sinφ φ̂, evaluate ∮ A · dl around the path shown in the following figure. (A) 0 (B)(C) (D) None of the above

8. The finite sheet 0 ≤ x ≤ 1 and 0 ≤ y ≤ 1 on the z = 0 plane has a surface charge density ρs = xy(x² + y² + 25)3/2 nC/m². Evaluate the electric field at (0, 0, 5).(A) -3 x̂ - 3 ŷ + 22.5 ẑ V/m (B) -3 x̂ - 3 ŷ + 11.25 ẑ V/m (C) -1.5 x̂ - 1.5 ŷ + 22.5 ẑ V/m (D) -1.5 x̂ - 1.5 ŷ + 11.25 ẑ V/m

9. In the following figure, two conducting cones of infinite extent with θ₁ and θ₂ are separated by an infinitesimal gap at R = 0. If 0 ＜ θ₁ ＜ θ₂ ＜ , V(θ₁) = 0, and V(θ₂) = 10 V, evaluate the potential distribution V(θ) between the cones. (A) 10V (B) 10 V (C) 10 [ln(tan θ cot θ₁)] / [ln(tan θ₂ cot θ₁)] V (D) 10 [ln(tan 2θ cot 2θ₁)] / [ln(tan 2θ₂ cot 2θ₁)] V

10. Consider a plane wave that is incident obliquely on an interface between two dielectric media of refractive indices of nᵢ and nₜ, as shown in the figure. We express the incident wave and transmitted wave as Eᵢ = E₀ᵢe^{i(kᵢ·r-ωt)} and Eₜ = E₀ₜe^{i(kₜ·r-ωt)}, respectively. Here, kᵢ, kᵣ, and kₜ are the wave vectors of the incident wave, reflected wave, and transmitted wave, respectively. These wave vectors are all on the same plane. Which one of the following relations is correct? (A) kᵢcosθᵢ = kₜcosθₜ (B) kᵢsinθᵢ = kₜsinθₜ (C) kᵢnᵢsinθᵢ = kₜnₜsinθₜ (D) None of the above

11. Consider an ideal lossless transmission line with the characteristic impedance R₀ = 50 Ω. The transmission line is connected to a load which is composed of a resistor R = 25 Ω and a capacitor C = 0.2 pF in series. The signal frequency is at 10 GHz. If we want to use the Smith chart for determining the signal reflectivity at the load interface, please refer to the following figure and determine inside which quadrant (象限) of the Smith chart the data point will be located: (A) I (B) II (C) III (D) IV

114年 - 114 台灣聯合大學系統_碩士班招生考試試題_電機類：電磁學#138442

113年 - 113 台灣聯合大學系統_碩士班招生考試試題_電機類：電磁學#138444

112年 - [無官方正解]112 台灣聯合大學系統_碩士班招生考試試題_電機類：電磁學#138446

111年 - 111 台灣聯合大學系統_碩士班招生考試試題_電機類：電磁學#138448

110年 - 110 國立臺灣大學_碩士班招生考試_電信工程研究所甲組:電磁學及電磁波#113085

110年 - 110 國立臺灣科技大學_碩士班招生試題_電子工程系(丙組)：電磁學#112842

110年 - 110 國立臺灣科技大學_碩士班招生試題_光電工程系：電磁學#111696

110年 - 110 國立臺北科技大學_碩士班招生考試_光電工程系碩士班：電磁學#108271

110年 - 110台灣聯合大學系統_碩士班招生考試_電機類:電磁學#105808

110年 - 110 國立中央大學_碩士班招生考試_光電類:電磁學#105700