(b) (10%) If the sustained oscillation occurs, what will be the oscillation frequency (in Hz)?

 (a)(10%) Estimate the quality factor of the equivalent smnall-signal LCR circuit seen at the collectorof Q.

 (c)(10%) Calculate the small-signal transconductance gm of the transistor Q, and determine if thefeedback gain is large enough to cause oscillation. Justify your answer.

 2. (20%) Suppose we want to convert v(t)=cos(10t) to v(t) = Axsin(10t) by a phase shift circuit in Fig. 2. Determine the value of R, and what will be the output amplitude A in this case?

3. (20%) A series RC circuit is utilized to equalize the impedance of an inductive load in Fig. 3. Determine the value of C in Fig. 3 so that the overall impedance Z becomes a pure resistance of 50 ohm in the entire frequency band.

(a) (10%) Determine VG.

(b) (10%) Determine the minimum allowed that still assures that M works properly as a constant current source.

(c) (10%) Suppose the 15V supply voltage has 1% variations on it (i.e.,△ =± 0.15V). Estimate the percentage change in current Io. Notefor M in saturation.

4. (30%) Figure 4 shows a CC-CE amplifier with = RL = 5 kΩ, I1 = I2 = 1mA, and identical transistors with β = 100, fT = 500 MHz, Cμ = 5pF, and Cc = 2uF. The thermal voltage VT= 25mV. For simplicity, neglect ro and rx effect. Please find (a) the input resistance(b) the midband gain AM, (c) the Cπof the BJTs, and (d) 3-dB frequency of the upper end of the midband, fH (using open-circuit time- constants method). (5%, 5%, 5%, 15%)

3. (30%) Figure 3 is the two-stage CMOS op amp configuration. All NMOSFETs have the same W/L = 10um/0.5um, = 0.5V, = 200 uA/V2. All PMOSFETs have the same WIL = 40um/0.5pμm, = -0.5V, = 50 μA/V2. IVAI (for all devices) = 100μ.A. Neglect the effect of VA on bias current. Please find (a) the transconductance gm and ro of Q2, (b) the voltage gain of the furst stage A1 and the second stage A2, (c) the input common-mode range, and (d) the output voltage range.(10%, 10%, 5%, 5%)

2.(25%) Consider the voltage amplifier of Figure 2 with a BJT device having β =100 when it is biased in the active region, the AC signal voltage Vsig, signal resistance = 10kΩ and coupling capacitors and which can block DC component and pass AC component. The voltage supplies = 10V and the thermal voltage VT= 25mV. The constant voltage drop 0.7V approximation can be used for the turn- on of a p-n junction, and the constant voltage drop ~ 0.2V approximation can be used when the BJT is biased in the saturation region. In addition, other resistances are also included, such like R1 = 2MΩ, R2 = 2MΩ, RE = 5kΩ, Rc = 5kΩ, RL= 5kΩ. Please come out following parameters: (a) transconductance gm, (b) input resistance, (c) overall AC voltage gain (d) Please describe the advantages of the existing of emitter resistance Re compared with no RE. (5%, 5%, 5%, 10%)

110年 - 110 國立中山大學_碩士班招生考試_電機系(甲組)：電子學(甲組)#106054

110年 - 110 國立中山大學_碩士班招生考試_電機系(戊組)、通訊所(乙組)、電波聯合：電子學#104281

109年 - 109 國立中山大學_碩士班招生考試_電機系(甲組)：電子學(甲組)#106048

107年 - 107 國立中山大學_碩士班招生考試_電機系(甲組)：電子學#110217

107年 - 107 國立中山大學_碩士班招生考試_電波領域：電子學#108992

106年 - 106 國立中山大學_碩士班招生考試_電波領域：電子學#110216

106年 - 106 國立中山大學_碩士班招生考試_電機系(甲組)：電子學#108988

105年 - 105 國立中山大學_碩士班招生考試_電機系(甲組)(己組)：電子學#110214

104年 - 104 國立中山大學_碩士班招生考試_電機系(甲組、乙組、戊組)、電波領域：電子學#110220

103年 - 103 國立中山大學_碩士班招生考試_電機系(甲、乙、戊組)、電波領域：電子學#110218