11. Which of these statements about benzene is true?
(A) All carbon atoms in benzene are sp³ hybridized.
(B) Benzene contains only π bonds between C atoms.
(C) The bond order of each C—C bond in benzene is 1.5.
(D) Benzene is an example of a molecule that displays ionic bonding.
(E) All of these statements are false.

7. Which of the following concentration measures will change in value as the temperature of a solution changes? (A) mass percent (B) mole fraction (C) molality (D) molarity (E) all of these

8. A solution containing 296.6g of Mg(NO3)2 per liter has a density of 1.114 g/mL. The molarity of the solution is: (Mg(NO3)2:148.3 g/mol). (A) 2.000 M (B) 2.446 M (C) 6.001 M (D) 1.805 M (E) none of these

9. Calculate the molality of C2H5OH in a water solution that is prepared by mixing 50.0 mL of C2H5OH with 100.0 mL of H2O at 20℃. The density of the C2H5OH is 0.789 g/mL at 20℃. (C2H5OH: 46.07 g/mol. Density of H2O is 1 g/cm3). (A) 0.086 m (B) 0.094 m (C) 1.24 m (D) 8.56 m (E) none of these

10. Which statement about N2 is false? (A) It is a gas at room temperature. (B) The oxidation state is +3 on one N and -3 on the other. (C) It has one sigma and two pi bonds between the two atoms. (D) It can combine with H2 to form NH3. (E) It has two pairs of nonbonding electrons.

12. When electrons in a molecule are not found between a pair of atoms but move throughout the molecule, this is called . (A) ionic bonding (B) covalent bonding (C) polar covalent bonding (D) delocalization of the electrons (E) a dipole moment

13. Which one of the following descriptions for microelectrodes is incorrect? (A) The dimensions of such electrodes are usually smaller than about 20 μm. (B) The IR (current × resistance) drop of microelectrodes is higher than traditional electrodes. (C) Such electrodes can be used for the study of chemical processes in single cells. (D) They are also called ultramicroelectrodes or microscopic electrodes. (E) By using such electrodes, three electrodes system is not necessary.

14. Which one of the following descriptions about GC (gas chromatography) is correct? (A) In GC, the stationary phase is liquid or solid, the mobile phase is gas. (B) It can only be applied for gaseous samples. (C) In order to obtain a complete separation, different gaseous mixtures are purged into the column successively. (D) GC is not an efficient separation technique. (E) All of these are correct.

15. Which one of the following detectors is not used for HPLC (high-performance liquid chromatography)? (A) Absorbance detectors (B) Fluorescence detectors (C) Electrochemical detectors (D) Flame ionization detectors (E) Mass spectrometers

16. Which one of the following descriptions about CE (capillary electrophoresis) is incorrect? (A) Electrophoresis is a separation technique based on the different migration rates of charged species. (B) It cannot be used to separate proteins and nucleic acids. (C) Its particular strength is the unique ability to separate charged macromolecules. (D) Until the appearance of CE, electrophoretic separations were not carried out in columns. (E) Most of the detectors used for HPLC can be employed for CE.

17. The pH meter is widely used for measuring the H+ concentrations in the solutions. Which one of the following descriptions for a pH is incorrect? (A) The sensing material is a special thin glass membrane at the tip of the electrode. (B) No reference electrode is required for a pH meter. (C) The real signal obtained from the pH meter is voltage (or difference of potentials). (D) In basic solutions, the indicator electrode also responds to alkali metal ions. (E) pH meters can be used to determine the equivalence point of the acid-base titration.